Toyota Corolla (E170): Other interior features

Share this page:

Other materials:

Rear door belt moulding assy lh
Replacement Hint: the installation procedures are the removal procedures in reverse order. Use the same procedures for the rh side and lh side. 1. Remove rear armrest assy lh 2. Remove power window regulator switch assy rear (w/ power window) 3. Remove rear door window regulator han ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Inspection procedure
1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...