Toyota Corolla (E120): Open in p squib circuit

Dtc b0106/54 open in p squib circuit

Share this page:

Other materials:

Fuel system
Precaution 1. Before working on fuel system, disconnect negative (–) terminal cable from battery 2. Do not smoke or work near an open flame when working on fuel system 3. Keep gasoline away from rubber or leather parts 4. Work for prevent gasoline from spilling out Remove the rear s ...

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

Overhaul
Hint: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove t ...