Toyota Corolla (E120): Open in p squib (2nd step) circuit

Dtc b1186/58 open in p squib (2nd step) circuit

Share this page:

Other materials:

Diagnostic trouble code chart
Notice: when removing the part, turn the ignition switch to off. Hint: using sst 09843–18040, it connect the terminal tc and cg of dlc3. If any abnormality is not found when inspecting parts, inspect the ecu and ground points for poor contact. If a malfunction code is displayed during ...

Inspection procedure
1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove radiator grille sub–assy Remove the 2 bolts and clip.  using a screwdriver, remove the radiator grille. Hint: tape the screwdriver tip before use. ...