Toyota Corolla (E120): On–vehicle inspection

1. Inspect w/receiver condenser assy

  1.  if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air.

Notice

: do not damage the fin of the w/receiver condenser assy.

  1.  if a fin of the w/receiver condenser assy is bent, make it straight using a screwdriver or pliers.

2. Inspect w/receiver condenser assy for leakage of refrigerant

  1.  using a halogen leak detector, check pipe joints for gas leakage.
  2.  if gas leakage is detected in a joint, check the torque of the joint.
    Share this page:

    Other materials:

    Vehicle lift and support locations
    1. Notice about vehicle condition when jacking up As a rule, the vehicle must be unloaded when jacking up. Never jack up or lift up the vehicle loaded with things of heavy weight.  when removing any parts of heavy weight like the engine and transmission, the center of gravity of ...

    Pre–check
    1. Srs warning light check Turn the ignition switch to the on position and check that the srs warning light lights up. check that the srs warning light goes out after approx. 6 Seconds. Hint: when the ignition switch is at on and the srs warning light remains on or flashes, the ...

    Using the interior lights
    Interior lights list 1 Front interior light/personal lights 2 Rear interior light 3 Engine switch light (vehicles with a smart key system) Front interior light/personal lights ■ Front interior light ► Type A ► Type B 1 Off 2 Door position 3 On ■ Personal li ...