Toyota Corolla (E120) 2002–2008 Repair Manual / Brake / Proportioning valve assy / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Install lspv gauge (sst) and bleed air
- remove the bleeder plugs from the front and rear brake cylinder.
- install the lspv gauge (sst), and bleed the air.
Sst 09709–29018
2. Raise master cylinder pressure and check rear wheel cylinder pressure
Hint
: when inspecting the fluid pressure, inspect the left front and right rear together, and the right front and left rear together. If the rear wheel cylinder pressure is imprper, replace the proportioning valve assy.
3. Remove lspv gauge (sst)
- remove the lspv gauge (sst).
Sst 09709–29018
- install the bleeder plugs.
Torque: 8.3 Nvm (85 Kgf·cm, 74 in.Vlbf)
4. Bleed master cylinder
sst 09023–00100
5. Bleed brake line
6. Check for leaks
Other materials:
Hood
Adjustment
Hint:
since the centering bolt is used as a hood hinge and hood lock
set bolt, the hood and hood lock can not be adjusted with it on.
Substitute a bolt with washer for the centering bolt.
1. Inspect hood sub–assy
Check that the clearance is within the standard value.
...
Inside vehicle
General maintenance
Performing these maintenance checks on the vehicle in the owner’s
responsibility. The owner may
perform the maintenance or take the vehicle to a service center.
Check the parts of the vehicle described below on a daily basis. In most cases,
special tool are not
requir ...
Inspection procedure
1 Check low pitched horn assy
Connect the positive (+) lead from the battery to the terminal
and negative (–) lead to the horn body, and check that
the horn blows.
2 Check relay (marking: horn)
Remove the relay from the engine room j/b.
check the horn relay conti ...