Toyota Corolla (E120): On–vehicle inspection

1. Inspect front axle hub bearing

  1.  remove the front wheel.
  2.  separate the front disc brake caliper assy .
  3.  remove the front disc.
  4.  inspect the bearing backlash.

  1. Using a dial indicator, check the backlash near the center of the axle hub.

    Maximum: 0.05 Mm (0.0020 In.)

If the backlash exceeds the maximum, replace the front axle hub bearing.

  1.  inspect the axle hub deviation.

  1. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.

    Maximum: 0.05 Mm (0.0020 In.)

If the backlash exceeds the maximum, replace the front axle hub sub–assy.

  1.  install the front disc.
  2.  install the front disc brake caliper assy .
  3.  install the front wheel.

    Torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)

2. Inspect rear axle hub bearing

  1.  remove the rear wheel.
  2.  remove rear brake drum sub–assy.
  3. inspect the bearing backlash.

  1. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft sirection.

    Maximum: 0.05 Mm (0.0020 In.)

If the backlash exceeds the maximum, replace the rear axle hub & bearing assy.

  1. Inspect the axle hub deviation.

  1.  Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.

    Maximum: 0.07 Mm (0.0028 In.)

If the backlash exceeds the maximum, replace the rear axle hub & bearing assy.

  1.  install the rear brake drum sub–assy.
  2.  install the rear wheel.

    Torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)

    Share this page:

    Other materials:

    Turn signal lever
    Operating instructions 1 Right turn 2 Lane change to the right (move the lever partway and release it) The right hand signals will flash 3 times. 3 Lane change to the left (move the lever partway and release it) The left hand signals will flash 3 times. 4 Left turn ■Turn signals can b ...

    Replacement
    1. Remove battery 2. Remove battery carrier Remove the 4 bolts and battery carrier. 3. Disconnect floor shift cable transmission control shift Remove the nut from the control shaft lever.  disconnect the control cable from the control shaft lever.  remove the clip a ...

    Valve clearance
    Adjustment 1. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 2. Disconnect engine wire Remove the 5 clamps from the 5 clamp brackets. Disconnect the 4 ignition coil connectors. Remove the bolt and nut installing the engine wire ...