Toyota Corolla (E120): On–vehicle inspection

1. Check fuel pump operation

  1. Connect the hand–held tester to the dlc3.
  2.  turn the ignition switch on and hand–held tester main switch on.

    Notice

    : do not start the engine.

  3.  select the active test mode on the hand–held tester.
  4.  please refer to the hand–held tester operator’s manual for further details.
  5.  if you have no hand–held tester, connect the positive (+) lead form the battery to terminal 4 of the connecter, and the negative (–) lead to terminal 5.

Notice

:

  • these tests must be done quickly (within 10 seconds) to prevent the coil burning out.
  • Keep the fuel pump as far away from the battery as possible.
  • Always do the switching at the battery side.

2. Check fuel pressure

  1. Prepare for inspection.
  1.  Purchase a new fuel tube, and take out the fuel tube connector from its tube.

Hint

: part no. 23901–0D010

  1.  work for prevent gasoline from spilling out.

     

  2.  disconnect the efi fuel pipe clamp.
  3.  disconnect the fuel tube from the fuel main tube.

     

  1. Install sst (pressure gauge) as shown in the illustration by using the sst and fuel tube connector.

    Sst 09268–41047 (90467–13001, 95336–08070), 09268–45014 (09268–41200, 09268–41220, 09268–41250, 90467–13001)

  2.  wipe off any splattered gasoline.
  3. ) start the engine.
  4.  measure the fuel pressure at idle.

    Fuel pressure: 304 – 343 kpa (3.1 – 3.5 Kgfvcm2, 44 – 50 psi)

  5.  stop the engine.
  6.  check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.

    Fuel pressure:
    147 kpa (1.5 Kgfvcm2, 21 psi) or more

If pressure is not as specified, check the fuel pump, pressure regulator and/or injectors.

  1.  after checking fuel pressure, disconnect the negative (–) terminal cable from the battery and carefully, remove the sst and fuel tube connector to prevent gasoline from the splashing.
  2.  reconnect the fuel tube to fuel main tube.
  3.  install the efi fuel pipe clamp.
  4.  check fuel leak.
    Share this page:

    Other materials:

    Vehicle control system
    Ignition or starter switch assy Replacement 1. Remove steering column cover 2. Remove ignition or starter switch assy Disconnect the ignition switch connector and unlock warning switch connector.  remove the 2 clamps.  remove the 2 screws and ignition switch. Inspectio ...

    Check short circuit
    If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b). Check the resistance with the body ground.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 ...

    Inspection
    1. Windshield wiper switch assy Continuity check  check the continuity of each terminal of the connector. Front wiper switch Standard: Front washer switch Standard: W/o intermittent time adjust: intermittent operation check  connect the voltmeter (+) te ...