Toyota Corolla (E120) 2002–2008 Repair Manual / Sliding roof/convertible / Sliding roof system / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Inspect sliding roof function
- check the slide opening operation (manual).
- Turn the ignition switch on.
- When keeping operating the sliding roof switch to the open side, check that the roof glass will slide and be fully opened.
- check the slide closing operation (manual).
- Turn the ignition switch on.
- When keeping operating the slide roof switch to close side, check that the roof glass will slide but stop halfway.
- When operating the sliding roof switch to the close side again after the above operation, check that the roof glass will slide again from the halfway position and be fully closed.
2. Inspect sliding roof drive gear
- Disconnect the connector from the relay and switch, and inspect the connector on the wire harness side, as shown in the chart.
* Exceptions:
For 60 seconds after the ignition switch on → off (acc) or until the driver or passenger door is opened after the ignition switch on → off (acc).
If the result is not as specified, replace the relay.
Problem symptoms table
Other materials:
Adjustment
1. Inspect shift lever position
When shifting the shift lever to each position, make sure
that it moves smoothly, and the position indicator displays
correctly.
Positions which can be shifted without pressing the
shift lever knob button
r " n " d, l " 2 " d &quo ...
Inspection procedure
1 Check ignition or starter switch assy
Check the ignition switch, as shown in the illustration and
table.
Standard:
2 Check fuse (ecu–b)
Remove the fuse from the instrument panel j/b.
check the continuity of the fuse.
Standard: continuity
3 Check relay (m ...
Floor shift cable transmission control
shift (atm)
Replacement
1. Precaution
2. Disconnect battery negative terminal
3. Remove parking brake hole cover sub–assy
4. Remove console panel upper
5. Remove console box carpet
6. Remove console box sub–assy rear
7. Remove air bag sensor assy center
8. Disconnect oxygen sensor connector
...