Toyota Corolla (E120): On–vehicle inspection

1. Washer motor

  1. Operation check
  1. pour the water into the washer jar with the washer motor and the pump installed to the washer jar assy.
  2.  Connect the battery (+) to terminal 2 of the washer motor and the pump, the battery (–) to terminal 1 of the washer motor and the pump. Check that the water comes out from the washer jar.
    Share this page:

    Other materials:

    Side mudguard sub–assy lh
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...

    Things you should know
    ■ If you notice any symptoms If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check. If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer. CAUTION ■When using the rear view monitor system ...

    Inspection procedure
    1 Inspect transmission wire(slt) Disconnect the transmission wire connector from the transaxle. measure the resistance according to the value(s) in the table below. Standard: Measure the resistance according to the value(s) in the table below. Standard (check for short): ...