Toyota Corolla (E120) 2002–2008 Repair Manual / Heater & air conditioner / W/receiver condenser assy / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Inspect w/receiver condenser assy
- if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air.
Notice
: do not damage the fin of the w/receiver condenser assy.
- if a fin of the w/receiver condenser assy is bent, make it straight using a screwdriver or pliers.
2. Inspect w/receiver condenser assy for leakage of refrigerant
- using a halogen leak detector, check pipe joints for gas leakage.
- if gas leakage is detected in a joint, check the torque of the joint.
Other materials:
Circuit description
The speed sensor detects wheel speed and transmits the appropriate
signals to the ecu. These signals are used for control
of the abs control system. Each of the front and rear rotors has
48 serrations.
When the rotors rotate, the magnetic field generated by the permanent
magnet in the spe ...
Fuel information
You must only use unleaded gasoline in your vehicle.
Select octane rating 87 (Research Octane Number 91) or higher.
Use of unleaded gasoline with an octane rating lower than 87 may result in engine
knocking. Persistent knocking can lead to engine damage.
At minimum, the gasoline you use should ...
Replacement
1. Remove instrument panel sub–assy lower
2. Remove clutch pedal spring
3. Remove clutch master cylinder push rod clevis w/hole pin
Remove the clip and hole pin.
4. Remove clutch pedal support sub–assy
W/ cruise control:
disconnect the clutch switch assy connector.
&nbs ...


