Toyota Corolla (E120) 2002–2008 Repair Manual / Brake / Proportioning valve assy / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Install lspv gauge (sst) and bleed air
- remove the bleeder plugs from the front and rear brake cylinder.
- install the lspv gauge (sst), and bleed the air.
Sst 09709–29018
2. Raise master cylinder pressure and check rear wheel cylinder pressure
Hint
: when inspecting the fluid pressure, inspect the left front and right rear together, and the right front and left rear together. If the rear wheel cylinder pressure is imprper, replace the proportioning valve assy.
3. Remove lspv gauge (sst)
- remove the lspv gauge (sst).
Sst 09709–29018
- install the bleeder plugs.
Torque: 8.3 Nvm (85 Kgf·cm, 74 in.Vlbf)
4. Bleed master cylinder
sst 09023–00100
5. Bleed brake line
6. Check for leaks
Other materials:
Side mudguard sub–assy lh
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove side mudguard sub–assy lh
Using a clip remover, remove the 8 retainers and 9 clips.
using a moulding remover, remove the mudguard.
2. Install side mudguard sub–assy lh
Install the mudgu ...
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove air cleaner cap sub–assy
3. Remove air cleaner case sub–assy
remove the air cleaner element, then remove the 3 bolts and air
cleaner case sub–assy.
...
Inspection procedure
1 Inspect park/neutral position switch assy
Disconnect the park/neutral position switch connector.
measure resistance according to the value(s) in the table
below when the shift lever is moved to each position.
Standard:
2 Check harness and connector(park/neutral position ...