Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Manual transaxle oil
Toyota Corolla (E120): Manual transaxle oil
On–vehicle inspection
1. Inspect transaxle oil
- Stop the vehicle on the level place.
- remove the transmission filler plug and gasket.
- check that the oil surface is within 5 mm (0.20 In.) From the lowest position of the inner surface of the transmission filler plug opening.
Notice
:
- excessively large or small amount of oil may cause troubles.
- After replacing oil, drive the vehicle and check the oil level.
- check for oil leakage when the oil level is low.
- install the transmission filler plug and new gasket.
Torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf)
Other materials:
Replacement
Hint:
installation is in the reverse order of the removal. But the installation is
indicated only when it has a point.
1. Remove rear door opening trim rh
2. Remove rear door opening trim lh
3. Remove rear seat cushion assembly ( or 72–8)
4. Remove rear seat back assy (fixed type rear seat) ...
Overhaul
Notice: when installing, coat the parts indicated by the arrow with
power steering fluid or molybdenum disulfide lithium base grease.
1. Precaution
2. Disconnect battery negative terminal
3. Inspect center front wheel
4. Remove horn button assy
5. Remove steering wheel assy
sst 09950–50013 ...
Brake fluid
Bleeding
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
Hint:
if any work is done on the brake system or if air in the brake lines is
suspected, bleed the air from the system.
1. Fill reservoir with brake fluid
fluid: sae j1703 or fmvss no. ...