Toyota Corolla (E170): Manual air conditioning system∗

Air conditioning controls

► Heater

► Air conditioning system

► Air conditioning system

■ Adjusting the temperature setting

■ Adjusting the temperature setting

► Heater
To adjust the temperature setting, turn the ► Air conditioning system dial clockwise to increase the temperature.

► Air conditioning system To adjust the temperature setting, turn the (cool). dial clockwise (warm) or counterclockwise (cool).

If blow ambient temperature air or heated air. is not pressed, the system will blow ambient temperature air or heated air.

■ Fan speed setting

To adjust the fan speed, turn the (decrease). dial clockwise (increase) or counterclockwise (decrease).

Turning the dial to “0” turns off the fan.

■ Change the airflow mode

To select the air outlets, set the Other functions dial to the desired position.

Share this page:

Other materials:

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Shift solenoid ”a” performance (shift solenoid valve s1)
Dtc p0751 shift solenoid ”a” performance (shift solenoid valve s1) System description The ecm uses signals from the vehicle speed sensor and crankshaft position sensor to detect the actual gear position (1st, 2nd, 3rd or o/d gear). Then the ecm compares the actual gear with the shift sc ...

Shifting the shift lever
Vehicles without a smart key system: While the engine switch is in the “ON” position, depress the brake pedal and move the shift lever. Vehicles with a smart key system: While the engine switch is in IGNITION ON mode, depress the brake pedal and move the shift lever. When shifting the ...