Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Combination meter / Malfunction in tachometer
Toyota Corolla (E120): Malfunction in tachometer
Wiring diagram
Inspection procedure
- Check output value of ecm.
- Connect the hand–held tester to dlc3.
- Turn the ignition switch to on and push the hand–held tester main switch on.
- Select the data list mode on the hand–held tester.
2 Inspect combination meter assy
(Reference) inspection using oscilloscope
- check the input signal waveform.
- Remove the combination meter assy with connectors still connected.
- Connect the oscilloscope to the terminals c9–19 of combination meter assy and body ground.
- Start engine.
- Check the signal waveform.
3 Check harness and connector(between ecm and combination meter assy)
- Remove the combination meter.
- check the continuity between terminals 5 (tach) of ecm and c9–19 of combination meter connector.
Standard: there is continuity.
Check and replace ecm
Other materials:
Preparations to use wireless communication
The following can be performed using Bluetooth® wireless communication:
■ A portable audio player can be operated and listened to via multimedia system
■ Hands-free phone calls can be made via a cellular phone In order to use wireless
communication, register and connect a Bluetooth ...
Overhaul
1. Remove generator pulley
Sst 09820–63010 (09820–06010, 09820–06020)
Hint:
Hold sst 1 – a with a torque wrench, and tighten sst 1
– b clockwise to the specified torque.
Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf)
Notice:
check that sst is secured to the rotor shaft.
...
Emergency flashers
The emergency flashers are used to warn other drivers when the vehicle has
to be stopped in the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch once again.
■Emergency flashers
If the emergency flashers are used ...