Toyota Corolla (E170): Maintenance and care

Share this page:

Other materials:

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Dialing by selecting a name
1 Select “Phonebook” using . 2 Select the desired name using and press the off-hook switch. By pressing (Add S. Dial) and then one of the speed dial buttons (from to ) while the desired name is selected, it can be registered as a speed dial. ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...