Toyota Corolla (E170): Maintenance and care

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...

Outer rear view mirror assy lh
Replacement Hint: installation is according to the reverse order of the removal. In the rh side, work in the same procedure as in the lh side. 1. Remove front armrest assy lh 2. Remove power window regulator master switch assy (w/ power window) 3. Remove front armrest base panel upper ...

On–vehicle inspection
1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...