Toyota Corolla (E120): Lubrication

Preparation

Sst

Equipment

Equipment

Lubricant

Lubricant

Ignition

    Share this page:

    Other materials:

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the horn button assy.  for the black ...

    Towing your vehicle with 4 wheels on the ground
    To prevent damage to your vehicle, perform the following procedures before towing. 1 Shift the shift lever to N. 2 Turn the engine switch to the “ACC” position (without a smart key system) or ACCESSORY mode (with a smart key system). (, 166) Ensure that the audio system and other powered de ...

    Installing the spare tire
    1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...