Toyota Corolla (E170): Location of the spare tire, jack and tools

1 Luggage floor cover

1 Luggage floor cover 2 Wheel nut wrench
3 Jack handle
4 Jack attachment*
5 Jack
6 Spare tire
7 Tool tray

*: The jack attachment is used when raising your vehicle with a floor jack.

CAUTION

■Using the tire jack

Observe the following precautions.

Improper use of the tire jack may cause the vehicle to suddenly fall off the jack, leading to death or serious injury.

●Do not use the tire jack for any purpose other than replacing tires or installing and removing tire chains.

●Only use the tire jack that comes with this vehicle for replacing a flat tire.

Do not use it on other vehicles, and do not use other tire jacks for replacing tires on this vehicle.

●Put the jack properly in its jack point.

●Do not put any part of your body under the vehicle while it is supported by the jack.

●Do not start the engine or drive the vehicle while the vehicle is supported by the jack.

●Do not raise the vehicle while someone is inside.

●When raising the vehicle, do not put an object on or under the jack.

●Do not raise the vehicle to a height greater than that required to replace the tire.

●Use a jack stand if it is necessary to get under the vehicle.

●When lowering the vehicle, make sure that there is no-one near the vehicle. If there are people nearby, warn them vocally before lowering.

    Share this page:

    Other materials:

    Installing the spare tire
    1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...

    Instrument panel
    Engine switch Starting the engine/changing the positions*1 Starting the engine/changing the modes*2 Emergency stop of the engine When the engine will not start Warning messages Shift lever Changing the shift position Precautions for towing When the shift lever does not move Meters Read ...

    Circuit description
    The variable valve timing (vvt) system includes the ecm, the oil control valve (ocv) and the vvt controller. The ecm sends a target ”duty–cycle” control signal to the ocv. This control signal, applied to the ocv, regulates the oil pressure supplied to the vvt controller. Camshaft timin ...