Toyota Corolla (E170): Light bulbs

You may replace the following bulbs yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer.

For more information about replacing other light bulbs, contact your Toyota dealer.

Preparing for light bulb replacement

Check the wattage of the light bulb to be replaced.

Share this page:

Other materials:

Power outlet
The power outlet can be used for 12 V accessories that run on less than 10 A. Lift the lid while pulling up the knob and open the power outlet lid. ■The power outlet can be used when The engine switch is in ACC or ON. ■When turning the engine switch off Disconnect electrical devices with charg ...

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...

Inspection procedure
1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...