Toyota Corolla (E120): Instrument panel sub–assy lower

Share this page:

Other materials:

Out side moulding
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove outside moulding Put protective tape around the moulding.  insert a piano wire between the vehicle body and moulding.  tie objects that can serve as handles (for example, wooden blocks) to all ...

Check short circuit
If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b). Check the resistance with the body ground.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 ...

Inspection procedure
1 Check front airbag sensor (rh) circuit (to b+)(airbag sensor assy center – airbag front rh sensor) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag front rh sensor and the airbag sen ...