Toyota Corolla (E170): Installation with LATCH system

1 Widen the gap between the seat cushion and seatback slightly.

► Type A

2 Latch the hooks of the lower straps onto the LATCH anchors. If the child restraint has a top tether strap, the top tether strap should be latched onto the top tether strap anchor.

For owners in Canada: The symbol on a child restraint system indicates the presence of a lower connector system.

► Type B

► Type B

2 Latch the buckles onto the LATCH anchors. If the child restraint has a top tether strap, the top tether strap should be latched onto the top tether strap anchor.

For owners in Canada: The symbol on a child restraint system indicates the presence of a lower connector system.

Installing child restraints using a seat belt

    Share this page:

    Other materials:

    Inspection procedure
    Hand–held tester: 1 Check fuel tank cap assy(check that fuel tank cap is toyota genuine parts) 2 Check that fuel tank cap is correctly installed 3 Inspect fuel tank cap assy 4 Check filler neck for damage Remove the fuel tank cap.  visually check the fuel inlet pipe for ...

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Inspection procedure
    1 Check side air bag sensor assy lh Sst 09843–18040 Connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.  turn the ignition switch to on, and wait at least for 20 seconds.  clear the dtc stored in memory .  turn the ignition swi ...