Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Cruise control switch circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Input signal check
- See input signal check on page 05–745.
- check the indicator light operation when each of the set/
coast, resume/accel and cancel is turned on.
Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is on. The signal should disappear when the switch is turned off.
Cancel switch: the indicator light goes off when the cancel switch is turned on.
2 Inspect terminal voltage(ccs)
- Remove the cruise control ecu assy with the connector being connected.
- turn the ignition switch to on.
- measure the voltage between terminals 11 (ccs) of the
cruise control ecu assy connector and the body ground
when each control switch is operated.
Ok:
3 Inspect cruise control main switch assy
- Remove the steering wheel center pad .
- disconnect the control switch assy connector.
- check continuity between terminals 2 (ccs) and 3 (ecc)
of control switch assy connector when cruise control main
switch assy is held on and off.
Ok:
4 Check harness and connector(between cruise control main switch assy and body ground)
- Check for open and short circuit in harness and connector between cruise control main switch assy and body ground
5 Check harness and connector(between cruise control ecu assy and cruise control main switch assy)
- Check for open and short circuit in harness and connector between cruise control ecu assy and cruise control main switch assy
6 Input signal check(see step 1)
Check and replace cruise control ecu assy
Other materials:
Replacement
1. Drain engine oil
remove the oil pan drain plug and drain the engine oil.
2. Removal & installation chain sub–assy
3. Remove chain vibration damper no.1
remove 2 bolts and chain vibration damper no. 1.
4. Remove oil pump assy
Remove the 5 bolts.
rem ...
Floor shift cable transmission control
shift (atm)
Replacement
1. Precaution
2. Disconnect battery negative terminal
3. Remove parking brake hole cover sub–assy
4. Remove console panel upper
5. Remove console box carpet
6. Remove console box sub–assy rear
7. Remove air bag sensor assy center
8. Disconnect oxygen sensor connector
...
Circuit description
Refer to dtc c0200/31, c0205/32, c1235/35, c1236/36
Hint:
Dtc no. C0210/33, c1238/38 is for the right rear speed sensor.
Dtc no. C0215/34, c1239/39 is for the left rear speed sensor.
Wiring diagram
...