Toyota Corolla (E120): Inspection procedure

1 Check fuse(ecu–ig)

  1. Remove the ecu–ig fuse from the instrument panel j/b.
  2.  check the continuity of the ecu–ig fuse.

    Ok: continuity

2 Inspect terminal voltage(b)

2 Inspect terminal voltage(b)

  1. Remove the cruise control ecu assy with connector still connected.
  2.  turn the ignition switch to on.
  3.  measure voltage between terminals 2 (b) and 16 (gnd) of the cruise control ecu assy connector.

    Ok: voltage: 10 – 16 v

3 Check harness and connector(between cruise control ecu assy

3 Check harness and connector(between cruise control ecu assy and body ground)

  1. Measure resistance between terminal 16 (gnd) of the cruise control ecu assy connector and body ground.

    Ok: resistance: below 1 Ω

Check and repair harness and connector between cruise control ecu assy

Check and repair harness and connector between cruise control ecu assy and battery

    Share this page:

    Other materials:

    Foamed material application areas
    If an increase in temperature or other condition damages the foamed material when repairing or replacing the panel, fill in the insufficient areas with urethane foam. The following illustration shows the areas for one side, but the foamed material must be applied equally to both the left and r ...

    Malfunction in speedometer
    Wiring diagram Inspection procedure 1 Check combination meter assy Remove the combination meter assy with connector still connected.  check voltage.  Jack up either of the front wheels.  Shift the shift lever to neutral.  Turn the ignition switch to on ...

    Shifting the shift lever to R
    Shift the shift lever to R while lifting up the ring section. ■Maximum allowable speeds Observe the following maximum allowable speeds in each gear when maximum acceleration is necessary. mph (km/h) NOTICE ■To prevent damage to the transmission ●Do not lift up the ring ...