Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Park/neutral position switch circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check operation(starter)
- Check that the starter operates normally and that the engine starts.
2 Input signal check
- See input signal check on page 05–745.
- check the indicator light when shifting into except d position.
Ok: the indicator light goes off when shifting into except d position.
3 Inspect terminal voltage(d)
- Turn the ignition switch to on.
- measure voltage between terminal 4 (d) of cruise control
ecu assy connector and body ground when shifting into
d position and other positions.
Ok:
4 Check harness and connector(between cruise control ecu assy and park/neutral position switch)
- Check for open and short circuit in harness and connector between cruise control ecu assy and park/ neutral position switch
Check and replace cruise control ecu assy
Other materials:
Inspection procedure
1 Inspect stop lamp switch assy
2 Check harness and connector(stop lamp switch assy – ecm)
Install the stop lamp switch assy.
disconnect the ecm connector.
measure the voltage according to the value(s) in the table
below when the brake pedal is depressed and rele ...
Although system is powered,cd cannot be played
Wiring diagram
Inspection procedure
1 Check if a proper cd is inserted
Check that a proper cd is inserted.
Make sure that the cd is a normal audio cd, and that there is no
deformation, flaw, stain, burr
and other defects on the cd.
Standard: normal audio cd.
Reference:
...
Front suspension
Preparation
Sst
Recomended tools
Equipment
...