Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Stop light switch circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check operation(stop lamp swtich assy)
- Check that the stop light comes on when the brake pedal is depressed, and turns off when the brake pedal is released.
2 Input signal check
- See input signal check on page 05–745.
- check the indicator light when the brake pedal is depressed.
Ok: the indicator light goes off when the brake pedal is depressed.
3 Inspect terminal voltage(stp–)
- Remove the cruise control ecu assy with connectors still connected.
- turn the ignition switch to on.
- measure voltage between terminal 3 (stp–) of cruise
control ecu assy connector and body ground, when the
brake pedal is depressed and released.
Ok:
4 Check harness and connector(between cruise control ecu assy and stop lamp switch assy)
- Check for open and short circuit in harness and connector between cruise control ecu assy and stop lamp switch assy
Check and replace cruise control ecu assy
Other materials:
Sliding roof/convertible
Service data
Torque specification
Engine hood/door
Torque specification
Exterior/interior trim
Torque specification
Cruise control
Service data
Torque specification
...
Checking the messages
1 Display the “Message Inbox” screen.
2 Select the desired message from the list.
3 Check that the message is displayed.
1 E-mails: Select “Mark Unread” or “Mark Read” to mark mail unread or read on
the message inbox screen.
This function is available when “Update Message Read S ...
Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument
panel passenger airbag assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector between the airbag sensor
assy center and the instrument panel ...