Toyota Corolla (E120): Inspection procedure

1 Inspect terminal voltage(idl)

  1. Remove the cruise control ecu assy with connector still connected.
  2.  disconnect the ecm connector.
  3.  turn the ignition switch to on.
  4.  measure voltage between terminal 13 (idl) of cruise control ecu assy connector and body ground when the throttle valve is fully closed and fully opened.

    Ok:

2 Check harness and connector(between cruise control ecu assy

2 Check harness and connector(between cruise control ecu assy and ecm)

  1. Check for open and short circuit in harness and connector between cruise control ecu assy and ecm

Check and replace cruise control ecu assy

Check and replace cruise control ecu assy

    Share this page:

    Other materials:

    Diagnosis system
    Description  when troubleshooting obd ii vehicles, the only difference from the usual troubleshooting procedure is that you need to connect an obd ii scan tool complying with sae j1987 or a hand–held tester to the vehicle, and read off various data output from the vehicle†...

    Inspection procedure
    Hint: if different dtcs related to different systems that have terminal e2 as the ground terminal are output simultaneously, terminal e2 may be open. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malf ...

    Noise occurs
    Inspection procedure 1 Check of speaker installation Check speaker installation condition.  Check that each speaker is securely installed. Standard: malfunction disappear. Hint: the radio is equipped with noise prevention system that does not work against the regular use of t ...