Toyota Corolla (E120): Inspection procedure

1 Inspect cruise control actuator assy

  1. Turn the ignition switch to off.
  2.  disconnect the cruise control actuator assy connector.
  3.  measure the resistance between terminals 1 (mo) and 2 (mc) of cruise control actuator assy.

Hint

: if control plate position is fully opened or fully closed, resistance cannot be measured.

Ok: resistance: more than 4.2 Ω

2 Check harness and connector(between cruise control ecu assy

2 Check harness and connector(between cruise control ecu assy and cruise control actuator assy)

  1. Check for open and short circuit in harness and connector between cruise control ecu assy and cruise control actuator assy (actuator motor)

Check and replace cruise control ecu assy

Check and replace cruise control ecu assy

    Share this page:

    Other materials:

    Customizing vehicle features
    It is possible to customize the language and Eco Driving Indicator Light settings using the “DISP” switch. When customizing vehicle features, ensure that the vehicle is parked in a safe place with the shift the shift lever to P (continuously variable transmission) or N (manual transmissio ...

    Overhaul
    Hint: components: 1. Remove rear wheel 2. Remove spare wheel cover assy 3. Remove rear floor finish plate 4. Remove luggage compartment trim cover inner lh 5. Remove rear shock absorber with coil spring Support the rear axle beam with jack. Remove the 2 nuts and bolt. ...

    Adjustment
    1. Headlight aim only  place the vehicle in the following conditions. The area around the headlight is not deformed. The vehicle is parked on a level surface. Tire inflation pressure is in the specified value . A driver is in the driver’s seat and the vehicle is in a state rea ...