Toyota Corolla (E120): Inspection procedure
1 Check un–lock warning switch assy
- Disconnect the key unlock warning switch connector.
- check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table.
Standard:
2 Check wire harness (tvip ecu unlock warning switch)
- Disconnect the tvip ecu and key unlock warning switch connectors.
- check the continuity between the terminals of the tvip ecu connectors and unlock warning switch connector, as shown in the illustration and table.
Standard:
3 Check wire harness (key unlock warning switch body ground)
- Disconnect the key unlock warning switch connector.
- check the continuity between the terminal of the key unlock warning switch connector and the body ground, as shown in the illustration and table.
Standard:
Check and replace tvip ecu
Other materials:
Replacement
Hint:
installation is in the reverse order of the removal. But the installation is
indicated only when it has a point.
1. Remove spare wheel cover assy
2. Remove rear floor finish plate
Remove the 3 clips.
using a moulding remover, remove the rear floor finish
plate.
3. Rem ...
Exterior
Doors
Locking/unlocking
Opening/closing the side windows
Locking/unlocking by using the mechanical key*1
Warning messages
Trunk
Opening from inside
Opening from outside
Warning messages
Outside rear view mirrors
Adjusting the mirror angle
Folding the mirrors
Defogging the mirrors*2
...
Diagnostic trouble code chart
Hint:
when the srs warning light remains lit up and the dtc is the normal
code, this means a voltage source
drops.
This malfunction is not stored in memory by the airbag sensor assy center
and if the power source
voltage returns to normal, the srs warning light will autom ...