Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system / Starter cut relay circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check relay (marking: starter cut)
- Inspect the relay continuity, as shown in the illustration and table.
Standard:
2 Check tvip ecu
- Disconnect the tvip ecu connector.
- turn the ignition switch position to the start.
- measure the voltage between the terminal of the ecu connector and the body ground, as shown in the illustration and table.
Standard:
Check and replace tvip ecu
Other materials:
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the horn button assy
and the airbag sensor assy center.
for the oran ...
Inspection procedure
Hint:
perform the troubleshooting of dtc p0335 first. If no trouble is
found, troubleshoot the engine mechanical
systems.
Read freeze frame data using the hand-held tester or the obd ii scan tool.
Freeze frame data records
the engine conditions when a malfunction is detected. When tr ...
Turning on light switch does not light up night time
illumination of radio receiver
Wiring diagram
Inspection procedure
1 Inspect radio receiver assy(ill+, ill–)
Check that the voltage between terminals at each condition,
as shown in the chart.
Standard:
Repair or replace harness or connector ...