Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system / Horn relay circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check low pitched horn assy
- Connect the positive (+) lead from the battery to the terminal and negative (–) lead to the horn body, and check that the horn blows.
2 Check relay (marking: horn)
- Remove the relay from the engine room j/b.
- check the horn relay continuity, as shown in the illustration and table.
Standard:
3 Check wire harness (tvip ecu engine room j/b)
- Remove the horn relay from the engine room j/b.
- check the continuity between the terminals of the tvip ecu and engine room j/b connectors, as shown in the illustration and table.
Standard:
*: Horn relay terminal
4 Check wire harness (engine room j/b horn)
- Check the continuity between the terminals of the engine room j/b and horn connectors, as shown in the illustration and table.
Standard:
*: Horn relay terminal.
Check and replace tvip ecu
Other materials:
Inspection procedure
Hint:
read freeze frame data using the hand-held tester or the obd ii scan tool.
Freeze frame data records the
engine conditions when a malfunction is detected. When troubleshooting, it is
useful for determining whether
the vehicle was running or stopped, the engine was warmed up or not, the ...
Replacement
Hint:
installation is in the reverse order of the removal. But the installation is
indicated only when it has a point.
1. Remove spare wheel cover assy
2. Remove rear floor finish plate
Remove the 3 clips.
using a moulding remover, remove the rear floor finish
plate.
3. Rem ...
Supplemental restraint system
Preparation
Sst
Recomended tools
Equipment
...