Toyota Tacoma manuals

Toyota Corolla Repair Manual: Inspection procedure

1 Check wire harness(dlc3 – airbag sensor assy center)

  1. Turn the ignition switch to the lock position.
  2.  disconnect the aribag sensor assy center connector.
  3.  measure the resistance according to the value(s) in the table below.

Standard:

2 Check wire harness(cg of dlc3 – body ground)

2 Check wire harness(cg of dlc3 – body ground)

  1. Measure the resistance according to the value(s) in the table below.

Standard:

3 Check wire harness(tc of airbag sensor assy center – body

3 Check wire harness(tc of airbag sensor assy center – body ground)

  1. Measure the resistance according to the value(s) in the table below.

Standard:

Replace air bag sensor assy center

Replace air bag sensor assy center

Circuit description
Dtc output mode is set by connecting between tc and cg of the dlc3. The dtcs are displayed by blinking the srs warning light. Wiring diagram Hint: when each warning light stays blinking, gro ...

Audio system
...

Other materials:

Warning light and warning buzzer list
*1: Parking brake engaged warning buzzer: *2: Open door warning buzzer: *3: Vehicles with a drive monitor display *4: Vehicles with a multi-information display *5: Driver’s seat belt buzzer: Vehicles without a smart key system: The driver’s seat belt buzzer sounds to alert the drive ...

Inspection
1. Inspect sliding roof limit switch Inspect the sliding roof limit switch continuity. Standard: If the continuity is not as specified, replace the switch. 2. Inspect sliding roof drive gear sub–assy Connect the positive (+) lead from the battery to terminal 2 and the nega ...

Circuit description
The ecm compares the two waveforms of the heated oxygen sensors located before and after the catalyst to determine whether or not the catalyst performance has deteriorated. Air–fuel ratio feedback compensation keeps the waveform of the heated oxygen sensor in front of the catalyst alternate ...

© 2011-2024 Copyright www.tcorolla.net