Toyota Corolla (E120): Inspection procedure

1 Check source voltage

  1. Measure the voltage of the battery.

    Ok: voltage: 10 – 14 v

2 Check air bag sensor assy center

2 Check air bag sensor assy center

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  disconnect the connectors from the airbag sensor assy center.
  3.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  4.  turn the ignition switch to on.
  5.  check srs warning light light up in the combination meter assy.

    Ok: not srs warning light light up

3 Check wire harness(combination meter assy – airbag sensor assy

3 Check wire harness(combination meter assy – airbag sensor assy center)

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  disconnect the connector from the combination meter.

  1. Connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  2.  turn the ignition switch to on.
  3.  for the connector (on the airbag sensor assy center side) between the airbag sensor assy center and the combination meter, measure the voltage between la and body ground.

    Ok: voltage: below 1 v

Repair or replace combination meter assy or wire harness between

Repair or replace combination meter assy or wire harness between combination meter assy and battery

    Share this page:

    Other materials:

    Overhaul
    Hint: installation is in the reveres order of the removal. But the installation is indicated only when it has a point. In the rh side, work in the same procedure as in the lh side. 1. Remove rear armrest assy lh Using a screwdriver, remove the rear armrest. Hint: tape the s ...

    Luggage compartment door garnish outside
    Replacement Hint: the installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove luggage compartment lock cylinder & key set  remove the 2 nuts and luggage compartment lock cyl ...

    Adjustment
    1. Headlight aim only  place the vehicle in the following conditions. The area around the headlight is not deformed. The vehicle is parked on a level surface. Tire inflation pressure is in the specified value . A driver is in the driver’s seat and the vehicle is in a state rea ...