Toyota Corolla (E120): Inspection procedure
1 Check connector
- Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- check the connection of the combination meter connector and the
airbag sensor assy center connectors.
Ok: the connectors are connected.
2 Check combination meter assy
- Disconnect the connector from the combination meter.
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- Turn the ignition switch to on, and wait at least for 6 seconds.
- measure the voltage between sw and body ground.
Ok: voltage: above 8 v
3 Check instrument panel wire(airbag sensor assy center–combination meter assy)
- Turn the ignition switch to lock.
- disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- disconnect the connector from the airbag sensor assy center.
- measure the resistance between la and body ground.
Ok: resistance: 1mΩ or higher
Replace air bag sensor assy center
4 Check instrument panel wire(airbag sensor assy center–combination meter assy)
- For the connector (on the airbag sensor assy center side)
between the combination meter and the airbag sensor
assy center, measure the resistance between sw and
la.
Ok: resistance: below 1 Ω
Replace air bag sensor assy center
Srs warning light circuit malfunction (does not light up, when ignition switch is turned to on)
NextOther materials:
Registering a Bluetooth® audio player for the first time
To use the Bluetooth® Audio, it is necessary to register an audio player with
the system.
Once the player has been registered, it is possible to use the Bluetooth® Audio.
For details about registering a Bluetooth® device
1 Turn the Bluetooth® connection setting of your audio player on.
2 P ...
Body dimension drawings
Engine compartment
Body opening areas (side view: front)
Body opening areas (side view: rear)
Sedan
Body opening areas (rear view)
Sedan
Under body
Under body
Front suspension crossmember
Front suspension crossmember
...
Cd sound skips
Inspection procedure
1 Disc cleaning
Disk cleaning
) if the disk gets dirty, clean the disk by wiping the surface
from the center to outside in the radial directions
with a soft cloth.
Notice:
do not use a conventional record cleaner or anti–static preservative.
Standard: ...