Toyota Corolla (E120): Inspection procedure

1 Check airbag sensor assy center connector

  1. Disconnect negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  check the connection of the airbag sensor assy center connectors.

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  2.  turn the ignition switch to on, and wait at least for 20 seconds.
  3. clear the dtc stored in memory .
  4.  turn the ignition switch to lock, and wait at least for 20 seconds.
  5. ) turn the ignition switch to on, and wait at least for 20 seconds.
  6.  check the dtc .

    Ok: dtc b1135/24 is not output.

Hint

: codes other than code b1135/24 may be output at this time, but they are not relevant to this check.

3 Check perform a visual check of the disconnection detection pin

3 Check perform a visual check of the disconnection detection pin

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  with 3 connectors connected to the airbag sensor assy center, place tester leads onto any 2 of 3 disconnection detection pins and check for continuity.

    Ok: continuity

Replace air bag sensor assy center

Replace air bag sensor assy center

    Share this page:

    Other materials:

    Antenna cord sub–assy
    Replacement Hint: components: 1. Remove instrument panel sub–assy upper Hint: refer to the procedure until the step, ”remove instrument panel sub–assy upper” of instrument panel sub–assy lower. Remove the related parts as long as the antenna cord sub–assy can be removed ...

    Monitor description
    While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

    Bluetooth® device registration status
    1 Display the “Bluetooth* Setup” screen. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. 2 Select the device. 3 Select “Device Info”. 4 Following screen is displayed: 1 Device Name 2 Change connection method 3 Bluetooth® Address 4 Display your telephone number The n ...