Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Open in p/t squib (lh) circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh)
- Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- disconnect the connectors between the airbag sensor assy center and the seat belt pretensioner (lh).
- for the connector (on the seat belt pretensioner side) between
the airbag sensor assy center and the seat belt pretensioner
(lh), measure the resistance between pl+ and
pl–.
Ok: resistance: below 1 Ω
2 Check air bag sensor assy center
Sst 09843–18040
- Connect the connector to the airbag sensor assy center.
- using a service wire, connect pl+ and pl– of the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (lh).
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- clear the dtc stored in memory .
- turn the ignition switch to lock, and wait at least for 20 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- check the dtc .
Ok: dtc b0136/74 is not output.
Hint
: codes other than code b0136/74 may be output at this time, but they are not relevant to this check.
3 Check p/t squib (lh)
Sst 09843–18040
- Turn the ignition switch to lock.
- disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- connect the seat belt pretensioner (lh) connector.
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- clear the dtc stored in memory .
- turn the ignition switch to lock, and wait at least for 20 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- check the dtc .
Ok: dtc b0136/74 is not output.
Hint
: codes other than code b0136/74 may be output at this time, but they are not relevant to this check.
Use simulation method to check
Other materials:
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the horn button assy.
release the airbag activ ...
Steering column
Preparation
Sst
Recomended tools
Equipment
...
Circuit description
The park/neutral position switch detects the shift lever position and sends
signals to the ecm.
Monitor description
The park/neutral position switch detects the gearshift position and sends a
signal to the ecm.
For security, the park/neutral position switch detects the gearshift positio ...