Toyota Corolla (E120): Inspection procedure

1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh)

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensioner (rh).
  3.  for the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (rh), measure the resistance between pr+ and body ground.

    Ok: resistance: 1 mΩ or higher

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the connector to the airbag sensor assy center.
  2.  using a service wire, connect pr+ and pr– of the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (rh).
  3.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  4.  turn the ignition switch to on, and wait at least for 20 seconds.
  5.  clear the dtc stored in memory .
  6.  turn the ignition switch to lock, and wait at least for 20 seconds.
  7.  turn the ignition switch to on, and wait at least for 20 seconds.
  8.  check the dtc .

    Ok: dtc b0132/61 is not output.

Hint

: codes other than code b0132/61 may be output at this time, but they are not relevant to this check.

3 Check p/t squib (rh)

3 Check p/t squib (rh)

Sst 09843–18040

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  connect the seat belt pretensioner (rh) connector.
  4.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  5.  turn the ignition switch to on, and wait at least for 20 seconds.
  6.  clear the dtc stored in memory .
  7.  turn the ignition switch to lock, and wait at least for 20 seconds.
  8.  turn the ignition switch to on, and wait at least for 20 seconds.
  9.  check the dtc .

    Ok: dtc b0132/61 is not output.

Hint

: codes other than code b0132/61 may be output at this time, but they are not relevant to this check.

4 Use simulation method to check

4 Use simulation method to check

Replace all srs components including the wire harness

Replace all srs components including the wire harness

    Share this page:

    Other materials:

    Dialing from call history
    You can make a call using the call history, which has the 3 functions below. : calls which you missed : calls which you received : calls which you made 1 Display the phone screen. 2 Select “Call History” tab. 3 Select or the desired entry from the list. ► When is selected 4 C ...

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Using the steering wheel switches
    The steering wheel switches can be used to operate a connected cellular phone or portable digital audio player (portable player). Operating a Bluetooth® phone using the steering wheel switches 1 Volume The voice guidance volume cannot be adjusted using these buttons. 2 Off-hook switch Turns ...