Toyota Corolla (E120): Inspection procedure

1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh)

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensioner (rh).
  3.  for the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (rh), measure the resistance between pr+ and pr–.

    Ok: resistance: below 1 Ω

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the connector to the airbag sensor assy center.
  2.  using a service wire, connect pr+ and pr– of the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (rh).
  3.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  4.  turn the ignition switch to on, and wait at least for 20 seconds.
  5.  clear the dtc stored in memory .
  6.  turn the ignition switch to lock, and wait at least for 20 seconds.
  7.  turn the ignition switch to on, and wait at least for 20 seconds.
  8.  check the dtc .

    Ok: dtc b0131/64 is not output.

Hint

: codes other than code b0131/64 may be output at this time, but they are not relevant to this check.

3 Check p/t squib (rh)

3 Check p/t squib (rh)

Sst 09843–18040

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  connect the seat belt pretensioner (rh) connector.
  4.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  5.  turn the ignition switch to on, and wait at least for 20 seconds.
  6.  clear the dtc stored in memory .
  7.  turn the ignition switch to lock, and wait at least for 20 seconds.
  8.  turn the ignition switch to on, and wait at least for 20 seconds.
  9.  check the dtc .

    Ok: dtc b0131/64 is not output.

Hint

: codes other than code b0131/64 may be output at this time, but they are not relevant to this check.

Use simulation method to check

Use simulation method to check

    Share this page:

    Other materials:

    Fuel system
    Precaution 1. Before working on fuel system, disconnect negative (–) terminal cable from battery 2. Do not smoke or work near an open flame when working on fuel system 3. Keep gasoline away from rubber or leather parts 4. Work for prevent gasoline from spilling out Remove the rear s ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Inspection procedure
    Hint: read freeze frame data using the hand–held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, th ...