Toyota Corolla (E120): Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh)
- Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- disconnect the connectors between the airbag sensor assy center and the front seat airbag assy (lh).
- for the connector (on the front seat airbag assy side) between
the airbag sensor assy center and the front seat
airbag assy (lh), measure the resistance between sfl+
and body ground.
Ok: resistance: 1 mw or higher
2 Check air bag sensor assy center
Sst 09843–18040
- Connect the connector to the airbag sensor assy center.
- using a service wire, connect sfl+ and sfl– of the connector (on the front seat airbag assy side) between the airbag sensor assy center and the front seat airbag assy (lh).
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- clear the dtc stored in memory .
- turn the ignition switch to lock, and wait at least for 20 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- check the dtc .
Ok: dtc b0117/45 is not output.
Hint
: codes other than code b0117/45 may be output at this time, but they are not relevant to this check.
3 Check side squib(lh)
Sst 09843–18040
- Turn the ignition switch to lock.
- disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- connect the front front seat airbag assy (lh) connector.
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- clear the dtc stored in memory .
- turn the ignition switch to lock, and wait at least for 20 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- check the dtc .
Ok: dtc b0117/45 is not output.
Hint
: codes other than code b0117/45 may be output at this time, but they are not relevant to this check.
4 Use simulation method to check
Replace all srs components including the wire harness
Other materials:
Parking brake
Operating instructions
1 To set the parking brake, fully pull the parking brake lever while depressing
the brake pedal.
2 To release the parking brake, slightly raise the lever and lower it completely
while pressing the button.
*1: For U.S.A.
*2: For Canada
■Parking brake engaged wa ...
Rear axle lh hub bolt
Replacement
Hint: components:
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Remove rear axle lh hub bolt
Using sst and a hammer handle or an equivalent, remove
the lh hub bolt.
Sst 09628–10011
4. Install rear axle lh hub bolt
Install a washer and nut to a ...
Precaution
1. Work precautions
(A) vehicle protection
(1) when welding, cover glass, seats, carpets, etc. With
heat resistant fireploof covers to protect them.
(B) safety
(1) never stand in the path of the chain when using a puller
on the body or frame, and be sure to attach a safety
cable.
...