Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Short in side squib (lh) circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh)
- Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- disconnect the connectors between the airbag sensor assy center and the front seat airbag assy (lh).
- release the airbag activation prevention mechanism of the connector (on the airbag sensor assy center side) between the airbag sensor assy center and the front seat airbag assy (lh) .
- for the connector (on the front seat airbag assy side) between
the airbag sensor assy center and the front seat
airbag assy (lh), measure the resistance between sfl+
and sfl–.
Ok: resistance: 1 mw or higher
2 Check air bag sensor assy center
Sst 09843–18040
- Connect the connector to the airbag sensor assy center.
- using a service wire, connect sfl+ and sfl– of the connector (on the front seat airbag assy side) between the airbag sensor assy center and the front seat airbag assy (lh).
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- clear the dtc stored in memory .
- turn the ignition switch to lock, and wait at least for 20 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- check the dtc .
Ok: dtc b0115/47 is not output.
Hint
: codes other than code b0115/47 may be output at this time, but they are not relevant to this check.
3 Check side squib(lh)
Sst 09843–18040
- Turn the ignition switch to lock.
- disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
- connect the front seat airbag assy (lh) connector.
- connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- clear the dtc stored in memory .
- turn the ignition switch to lock, and wait at least for 20 seconds.
- turn the ignition switch to on, and wait at least for 20 seconds.
- check the dtc .
Ok: dtc b0115/47 is not output.
Hint
: codes other than code b0115/47 may be output at this time, but they are not relevant to this check.
Use simulation method to check
Other materials:
If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the vehicle
in the normal way, stop the vehicle using the following procedure:
1 Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required ...
How to proceed with troubleshooting
Troubleshoot in accordance with the procedure on the following pages.
1 Vehicle brought to workshop
2 Customer problem analysis check and symptom check
Without applicable symptoms, proceed to ”a”.
with applicable symptoms, proceed to ”b”.
3 Symptom simulation
4 Prob ...
Checking monitor status
Hint:
”monitor result” indicates normal or malfunction of each
component and system when judgment has done.
1. How to read data
Connect the hand–held tester to the dlc 3.
enter ”monitor result” from ”diagnosis / enhanced
obd ii / monitor info / monitor result”
on ...