Toyota Corolla (E120): Inspection procedure

1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh)

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy (rh).
  3.  for the connector (on the front seat airbag assy side) between the airbag sensor assy center and the front seat airbag assy (rh), measure the resistance between sfr+ and sfr–.

    Ok: resistance: below 1 w

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the connector to the airbag sensor assy center.
  2.  using a service wire, connect sfr+ and sfr– of the connector (on the front seat airbag assy side) between the airbag sensor assy center and the front seat airbag assy (rh).
  3.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  4.  turn the ignition switch to on, and wait at least for 20 seconds.
  5.  clear the dtc stored in memory .
  6.  turn the ignition switch to lock, and wait at least for 20 seconds.
  7.  turn the ignition switch to on, and wait at least for 20 seconds.
  8.  check the dtc .

    Ok: dtc b0111/44 is not output.

Hint

: codes other than code b0111/44 may be output at this time, but they are not relevant to this check.

3 Check side squib(rh)

3 Check side squib(rh)

Sst 09843–18040

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  connect the front seat airbag assy (rh) connector.
  4.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  5.  turn the ignition switch to on, and wait at least for 20 seconds.
  6.  clear the dtc stored in memory .
  7. turn the ignition switch to lock, and wait at least for 20 seconds.
  8.  turn the ignition switch to on, and wait at least for 20 seconds.
  9.  check the dtc .

    Ok: dtc b0111/44 is not output.

Hint

: codes other than code b0111/44 may be output at this time, but they are not relevant to this check.

Use simulation method to check

Use simulation method to check

    Share this page:

    Other materials:

    Gauges and meters (multi-information display)
    The displayed content may differ depending on the type of meter. 1 Tachometer Displays the engine speed in revolutions per minute. 2 Speedometer 3 Fuel gauge 4 Multi-information display The multi-information display presents the driver with a variety of drivingrelated data including the cu ...

    Inspection procedure
    1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Shift position uses
    *: Shifting to the D position allows the system to select a gear suitable for driving conditions. Setting the shift lever to the D position is recommended for normal driving. ■Downshifting restrictions The shift lever cannot be downshifted if the following speeds are exceeded. mph (km ...