Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / O/d cancel signal circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect terminal voltage(od – body ground)
- Disconnect the cruise control ecu connector.
- turn the ignition switch to the on position.
- measure the voltage between terminal od of cruise control ecu and body ground.
Standard:
2 Inspect terminal voltage(od1 – body ground)
- Measure the voltage between terminal od1 of ecm and body ground.
Standard:
3 Check harness and connector(od1 – body ground)
- Disconnect the ecm connector.
- measure the resistance according to the value(s) in the table below.
Standard (check for short):
Proceed to next circuit inspection shown on problem symptoms table
Other materials:
Overhaul
1. Remove bench type rear seat cushion assy
Disengage the 2 clamps, and then remove the seat cushion.
2. Remove separate type rear seat back assy
lean the seat back forward.
remove the 2 clips.
remove the 2 bolts and seat back lh.
employ the same manner describ ...
Calling the message sender
Calls can be made to an e-mail/SMS/MMS message sender's phone number.
1 Display the “Message Inbox” screen.
2 Select the desired message.
3 Select .
4 Check that the “Call” screen is displayed.
■ Calling from a number within a message
Calls can be made to a number identified ...
Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front
seat airbag assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the front seat airbag assy ...