Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / O/d main switch circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check harness and connector(transmission control switch – body ground)
- Disconnect the transmission control switch connector of shift lever assy.
- measure the resistance according to the value(s) in the table below.
Standard:
2 Inspect transmission control switch
- Measure the resistance according to the value(s) in the table below.
Standard:
3 Check harness and connector(transmission control switch – ecm)
- Connect the transmission control switch connector of shift lever assy.
- disconnect the ecm connector.
- measure the resistance according to the value(s) in the table below.
Standard:
Proceed to next circuit inspection shown on problem symptoms table
Other materials:
Connecting a Bluetooth® device
Up to 5 Bluetooth® devices (Phones (HFP) and audio players (AVP)) can be registered.
If more than 1 Bluetooth® device has been registered, select which device to
connect to.
1 Press the “SETUP” button.
2 Select “Bluetooth*”.
*: Bluetooth is a registered trademark of Bluetooth SIG, In ...
Monitor description
The battery supplies electricity to the ecm even when the ignition switch is
off. This electricity allows the
ecm store data such as dtc history, freeze frame data, fuel trim values, and
other data. If the battery voltage
falls below a minimum level, the ecm will conclude that there is a fault ...
Out side moulding
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove outside moulding
Put protective tape around the moulding.
insert a piano wire between the vehicle body and moulding.
tie objects that can serve as handles (for example, wooden
blocks) to all ...