Toyota Corolla (E120): Inspection procedure
1 Inspect transmission wire(s2)
- Disconnect the transmission wire connector from the transaxle.
- measure the resistance according to the value(s) in the table below.
Standard:
2 Check harness and connector(transmission wire – ecm)
- Connect the transmission connector to the transaxle.
- disconnect the connector from the ecm.
- measure the resistance according to the value(s) in the table below.
Standard:
Replace ecm
3 Inspect shift solenoid valve(s2)
- Remove the shift solenoid valve s2.
- measure the resistance according to the value(s) in the table below.
Standard:
- Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid body for checking the solenoid valve operation.
Standard: the solenoid makes an operating noise.
Repair or replace transmission wire
Other materials:
Overhaul
Notice:
when using a vise, do not over tighten.
When installing, coat the parts indicated by the arrows with power
steering fluid .
1. Remove front wheel rh
2. Drain power steering fluid
3. Remove engine under cover rh
4. Remove fan and generator v belt
5. Disconnect oil reservoir to ...
Luggage door hinge torsion bar rh
Replacement
Hint:
installation is in the reverse order of the removal. But the
installation is indicated only when it has a
point.
In the lh side, work in the same procedure as in the rh side.
Since the removal of the torsion bar will cause no tension, operation
of opening and closi ...
Inspection procedure
Hint:
read freeze frame data using the hand–held tester or the obd ii scan tool.
Freeze frame data records the
engine conditions when a malfunction is detected. When troubleshooting, it is
useful for determining whether
the vehicle was running or stopped, the engine was warmed up or not, th ...