Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect shift solenoid valve(s1)
- Remove the shift solenoid valve s1.
- measure the resistance according to the value(s) in the table below.
Standard:
- Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid body for checking the solenoid valve operation.
Standard: the solenoid makes an operating noise.
2 Inspect transmission valve body assy(see chapter 2 in the problem symptoms table)
Repair or replace automatic transaxle assy
Other materials:
Overhaul
1. Remove generator pulley
Sst 09820–63010 (09820–06010, 09820–06020)
Hint:
Hold sst 1 – a with a torque wrench, and tighten sst 1
– b clockwise to the specified torque.
Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf)
Notice:
check that sst is secured to the rotor shaft.
...
Handling of hose clamps
Before removing the hose, check the depth of the inserting
portion and the clamp position in order to restore it
surely.
change a deformed or dented clamp for a new one.
in case of reusing the hose, install the clamp on the hose
where it has a clamp track.
for a ...
Replacement
1. Remove engine under cover rh
2. Remove cylinder head cover no.2
Remove the 2 screw, 3 clips and engine under cover.
3. Remove fan and generator v belt
Turn the v–ribbed belt tensioner slowly clockwise and
loosen it. Then, remove the fan and generator v belt and
put back ...