Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / Brake switch ”b” circuit high / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect stop lamp switch assy


2 Check harness and connector(stop lamp switch assy – ecm)
- Install the stop lamp switch assy.
- disconnect the ecm connector.
- measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
Standard:



Replace ecm
Other materials:
Phone screen
To display the screen shown below, press the
switch on the steering wheel or the
button.
Several functions are available to operate on each screen that is displayed by
selecting the 4 tabs.
1 Device name
2 Bluetooth® connection status
■ Telephone switch
■ Microphone
υ ...
Inside vehicle
General maintenance
Performing these maintenance checks on the vehicle in the owner’s
responsibility. The owner may
perform the maintenance or take the vehicle to a service center.
Check the parts of the vehicle described below on a daily basis. In most cases,
special tool are not
requir ...
Circuit description
The ignition switch provides circuit power and the ecm provides the circuit
ground that illuminates the mil.
Mil operation is checked visually:
it should be illuminated when the ignition is first turned on. If the mil is off
all of the time or on all of the time,
use the procedure below to ...


