Toyota Corolla (E120): Inspection procedure
1 Inspect park/neutral position switch assy
- Disconnect the park/neutral position switch connector.
- measure resistance according to the value(s) in the table below when the shift lever is moved to each position.
Standard:
2 Check harness and connector(park/neutral position switch – ecm)
- Connect the the park/neutral position switch connector.
- turn the ignition switch to the on position, and measure the voltage according to the value(s) in the table below when the shift lever is moved to each position.
Standard:
Hint
: *: the voltage will drop slightly due to lighting up of the back up light.
Replace ecm
Other materials:
Uniform Tire Quality Grading
This information has been prepared in accordance with regulations issued by the
National Highway Traffic Safety Administration of the U.S. Department of Transportation.
It provides the purchasers and/or prospective purchasers of Toyota vehicles with
information on uniform tire quality grading.
...
Replacement
1. Discharge refrigerant from refrigeration system
turn the a/c switch on.
operating the cooler compressor at the engine rpm of approx. 1000
For 5 to 6 min., Circulate the refrigerant
and collect compressor oil remaining in each component into the cooler
compressor as much ...
Dialing from call histories
1 Select “All calls”, “Missed calls”, “Incoming calls” or “Outgoing calls” using
.
2 Select the desired number using
and press the off-hook switch.
The following operations can be performed:
● Registering a number as a speed dial
Press (Add S. Dial) and then press
an ...