Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / ABS with EBD system / Ts terminal circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
- Turn the ignition switch to on.
- measure voltage between terminals ts and cg of dlc3.
Ok: voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
- Check for open and short circuit in harness and connector between terminal cg of the dlc3 and body ground
3 Check harness and connector(skid control ecu – dlc3)
- Check for open and short circuit in harness and connector between terminal ts of the dlc3 and skid control ecu
Check and replace brake actuator assy
Other materials:
Overhaul
Hint: components:
1. Remove front wheel
2. Disconnect front stabilizer link assy lh
Remove the nut and disconnect the front stabilizer link
assy lh from the shock absorber assy front lh.
Hint:
if the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the st ...
Seat belt warning lamp for driver’s seat does not
operate
Wiring diagram
Inspection procedure
1 Check combination meter assy
Ground terminal c9–12 on the combination meter side.
check that the warning lightlights up.
Ok: warning light lights up.
2 Inspect front seat inner belt assy lh
Disconnect the front seat inner belt ...
Disposal
1. Dispose shock absorber assy front lh
fully extend the shock absorber piston rod.
using a drill, make a hole in the cylinder as shown in the
illustration to discharge the gas inside.
Caution:
when drilling, chips may fly out, work carefully.
The gas is colorless, o ...