Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / ABS with EBD system / Brake warning light circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect parking brake switch circuit
- Check for open and short circuit in parking brake switch circuit
2 Inspect brake fluid level warning switch circuit
- Check the brake fluid level in reservoir.
- check for open and shot circuit in brake fluid level warning switch circuit
3 Check dtc once more
- Check for open and short circuit in harness and connector between vacuum warning switch and skid control ecu
4 Inspect combination meter assembly(brake warning light circuit)
- Check for open and short circuit in combination meter
5 Check harness and connector(brake actuator – combination meter)
- Check for open and short circuit in harness and connector between brake actuator and combination meter
Check and replace brake actuator assy
Other materials:
Changing audio source
1 Press the “AUDIO” button to display the audio source selection screen.
If the audio source selection screen is not displayed, press the “AUDIO” button
again.
2 Select the desired audio source.
1 Select the desired audio source then
or
to reorder.
...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...
Starting system
Inspection
1. Inspect starter assy
Notice:
these tests must be performed within 3 to 5 seconds to
prevent burnout of the coil.
perform the pull–in test.
Remove the nut, then disconnect the lead wire from
terminal c.
Connect the battery to the starter repai ...