Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / ABS with EBD system / Abs warning light circuit (does not light up) / Inspection procedure
Toyota Corolla (E120): Inspection procedure
Hint
: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester.
1 Perform active test by hand–held tester(abs warning light)
- Check that ”on” and ”off” of the abs warning light can be shown on the combination meter by the hand–held tester.
2 Inspect combination meter assy(abs warning light)
- Disconnect the connector from the skid control ecu.
- turn the ignition switch to on.
- check the abs warning light.
Ok: abs warning light goes on
3 Check harness and connector(wa circuit)
- Check for short circuit in harness and connector of the between terminal wa of skid control ecu and combination meter
Check and replace brake actuator assy
Other materials:
Receiving a call
When a call is received, the following screen is displayed together with a
sound.
To answer the phone
Press the switch on the steering
wheel or select .
To refuse a call
Press the switch on the steering
wheel or select .
To adjust the incoming call volume
Turn the “PWR/VOL” knob. ...
Overhaul
1. Remove oil filler cap sub–assy
Remove the oil filler cap from the cylinder head cover.
2. Remove oil filler cap gasket
Using a screwdriver, remove the gasket from the oil filler
cap.
3. Remove ventilation valve sub–assy
Remove the ventilation valve from the cyl ...
Dialing from the contacts list
You can dial a number from the contact data imported from your cellular phone.
The system has one contact for each registered phone. Up to 2500 contacts may be
stored in each contact. 1 Display the phone screen.
2 Select “Contacts” tab.
3 Choose the desired contact to call from the list.
...