Toyota Corolla (E120): Inspection procedure
1 Inspect fuse(ecu–ig fuse)
- Remove ecu–ig fuse from the instrument panel j/b.
- check continuity of ecu–ig fuse.
Ok: continuity
2 Inspect battery
Ok: voltage: 10 – 14 v
3 Inspect skid control ecu connector(ig1 terminal voltage)
In case of using hand–held tester:
- check the voltage condition output from the ecu displayed on the
hand–held tester.
Ok: ”normal” is displayed.
In case of not using hand–held tester:
- disconnect the skid control ecu connector.
- turn the ignition switch to on.
- measure voltage between terminals ig1 (3) and gnd (1,
23) of skid control ecu harness side connector.
Ok: oltage: 10 – 14 v
4 Inspect skid control ecu connector(gnd terminal continuity)
Measure resistance between terminal gnd (1, 23) of skid control ecu harness side connector and body ground.
Ok: resistance: 1 Ω or less
Check and replace brake actuator assy
Other materials:
When using a child
restraint system
■ When installing a child
restraint system to a front
passenger seat
For the safety of a child, install a
child restraint system to a rear
seat. When installing a child
restraint system to a front passenger
seat is unavoidable,
adjust the seat as follows and
install the child restraint system:
M ...
Wiper & washer
Preparation
Sst
Recomended tools
Equipment
...
Inspection procedure
1 Inspect cruise control actuator assy
Inspect the cruise control actuator arm locking operation.
Turn the ignition switch to off.
Disconnect the cruise control actuator assy connector.
Connect the positive (+) lead from the battery to the
terminal 3 (l) of crui ...